DMA Mode Enabled Instructions

DMA mode must be enabled for all IDE drives in your system.

To do this in Windows 98 SE:

1. Select the Windows "Start" button -> "Settings" -> "Control Panel"
2. In the Control Panel folder double-click the "System" control panel.
3. Select the "Device Manager" tab 4.
4. Under the "Disk drives" branch, select the IDE drive(s) you are using.
5. Click on "Properties"
6. On the "Settings" Tab of the disk's properties dialog, make sure the "DMA" option is enabled.
7. Click "OK"
8. Close the "System" control panel and the Control Panel folder by clicking on the "Close" button
9. Windows will prompt you to restart your computer.
10. Repeat for all drives present in your computer

Once you have restarted follow steps 1-5 above once again to make sure "DMA" is in fact still set to enabled. If your computer is unable to keep this setting please contact your PC manufacturer.

If your computer does not have this option and you plan to setup a Digi 001 system (not audiomedia III), you should check your BIOS settings for options to enable bus masters.

Print this page or write these instructions, as you will need to restart your computer in order to access your system BIOS.

To access your computer's BIOS you must restart your computer. During the initial startup your computer will tell you which key to press in order to enter the setup program (typically DEL or F2 for Award). Press the corresponding key during startup. You should see an "Entering Setup" message. If present, make this change to your computer's BIOS:

Allow PCI Bus Masters = Enabled

In addition to checking the BIOS if dma is not available, you can also check in device manager under "Hard disk controllers" and make sure that you have the IDE controller and NOT the ATA controller. If you have the ATA controller you will need to Update the hard disk controller driver to the "standard dual IDE controller".