Release Notes for DAE/DSI 5.0cs4

Release Notes for DAE/DSI 5.0cs4

April 18, 2000

Version 5.0cs4 is an interim release that can be used with Pro Tools 5.0 TDM and Pro Tools 5.0 LE Systems. Preliminary testing has shown that this DAE/DSI combination fixes the following problems:

Digi 001 systems

  • Cannot generate MIDI Time Code (MTC) from the Digi 001 MIDI Output.

  • Analog Inputs 2, 4, 6 and 8 are delayed by 1 sample. Analog Outputs 1, 3, 5 and 7 are delayed by 1 sample.

  • S/PDIF Input 2 (R) is delayed by 1 sample and S/PDIF Output 1 (L) is delayed by 1 sample.

TDM systems with DSP Farm 1 cards

  • Certain Plug-Ins, e.g. D-Verb,are problematic (audio dropouts or no wet signal) when loaded on the first chip of a DSP Farm 1 card. (these have serial numbers below FF09226)

If you are not experiencing any of these symptoms with your current Pro Tools 5.0 TDM or Digi 001 system you should continue to use DAE/DSI 5.0.

Download Location

Installation Notes:

This is not an auto-installer, this download consists of DAE 5.0cs4, DSI 5.0cs4, and this ReadMe only.

  • Take your older DAE 5.0 out of the DAE Folder in your System Folder (save it in case you have any problems with this new version) and replace it with this version.

  • Take your older DSI 5.0 (named DigiSystemINIT) out of the Extensions Folder in your System Folder (save it in case you have any problems with this new version) and replace it with this version.

  • After changing DAE/DSI versions, always "trash your prefs". (delete the DAE Prefs folder in your System Folder/Preferences)

  • Reboot your computer.